|
Mounting Plates
|
|
Retention Caps (Pack of 50)
|
|
Magnetic inserts for mounting plates (pack of 20)
|
|
Inserts for mounting plates (pack of 20)
|
|
Incisal Table
Available in flat, 10° or 20° Prefabricated incisal table controls anterial guide element. |
|
Support Pin and Cap
|
|
Used for mounting maxillary cast.
Allows facebow to remain in practice. |
|
Permits use of non-KaVo facebows with a PROTAR articulator.
|
|
Model Positioner OK
|
|
Average value jig
|
|
Permits use of Denar facebow.
This would be inserted instead of the incisal pin |
|
Permits use of Panadent Facebow.
|
|
Plaster Mounting Set
Plaster Plate with integrated split cast. Allows Split Cast Check |
|
Plaster Mounting Sleeves
Facilitates plaster mounting in the articulator |
|
Incisal Pin
Included with every PROTAR evo Model Also sold as an accessory |
|
Incisal Pin "P"
|
|
Support Pin "T"
|
|
Orientation Tool
The tip indicates the incisal point of the mandible Bonwill's Triangle 110mm |
|
Fully Adjustable
Controls the anterial guide element |
|
Setup Template including long and short Calotte, Calotte support and Bite Fork support
A mandibular total prosthesis is set up using the setup calotte. All of the reference points are taken from the mandibular model. If a divided wax rim already exists, the calotte is aligned according with reference to the occlusal plane determined in the patient. Including long calotte. |
|
Calotte Holder
|
|
Bite Fork Support
|
|
Calotte (short)
|
|
Calotte (long)
|
|
PDR Inserts
Used with PROTAR evo 7 or 9 Enables 0 - 6 mm Distraction Enables 0 - 6 mm Protusion Enables 0 - 1 mm Retrusion |
|
Shift Angle Inserts
Used with PROTAR evo 7 Enables precise movement on the work side 0 - 20° lateroretrusion 0 - 20° lateroprotrusion |
|
Impression Screw
|
|
Tool for PROTAR evo
|
|
Carrying Case
Protect your PROTARevo with handy carrying case |
|
Contact us1-855-550-2769
519-267-2473 
|
